Baccalauréat 2022 — Physics-Chemistry specialty, Métropole, Mayotte, La Réunion, Antilles Guyane (jour 1) remplacement — exercise 2 : Exercise A — Observing Saturn’s Rings (officia
Statement
EXERCISE A - OBSERVING SATURN’S RINGS
Keywords: astronomical telescope
Saturn’s rings are among the most fascinating and most accessible objects for amateur astronomers to observe.
Depending on the quality of the observing instrument, several levels of observation of this planet can be distinguished. Figure 1 shows the first 4 levels accessible to the amateur astronomer.
Figure 1. First levels of observation of Saturn’s rings: photograph of Saturn by Voyager 2; diagrams indicating level 1: rings not visible (small gray oval disk), level 2: “ears” (disk with two lateral protrusions), level 3: visible rings (disk surrounded by a ring), level 4: Cassini Division (disk surrounded by rings separated by a dark division, arrow pointing to the Cassini Division).
In this exercise, we consider a commercial astronomical telescope and aim to determine which level of observation of Saturn it allows us to reach.
Data:
- throughout the exercise, we assume the following small-angle approximation, valid for any angle α, expressed in radians, very small compared with 1 rad: tan α ≈ α;
- the astronomical telescope studied has an objective with focal length $f'_1 = 700$ mm and can be used with different eyepieces.
1. Optical model of the commercial astronomical telescope
The astronomical telescope we will study is modeled by two converging thin lenses, denoted L₁ and L₂, having the same optical axis. The model of this telescope is shown in the figure in the APPENDIX TO BE SUBMITTED WITH THE ANSWER SHEET, where the object focal point F₂ of lens L₂ and the image focal points F’₁ and F’₂ of the two lenses are indicated.
In this first part, we consider the paths of the light rays modeling the propagation of light in the telescope. We denote by $f'_2$ the focal length of lens L₂.
Q1. Indicate, in the corresponding boxes on the figure in the APPENDIX TO BE SUBMITTED WITH THE ANSWER SHEET, the names “objective” and “eyepiece”.
Q2. Justify that the modeled astronomical telescope constitutes an afocal optical system.
Q3. Construct, on the figure in the APPENDIX TO BE SUBMITTED WITH THE ANSWER SHEET, the image of an object at infinity seen under an angle θ, formed by the astronomical telescope, by constructing the intermediate image and showing the angle θ’, the angle under which the final image is seen at the exit of the telescope.
Q4. Give the definition of the magnification G of the astronomical telescope as a function of the angles θ and θ’.
Q5. Establish the following expression for the magnification of the astronomical telescope: $G=\dfrac{f'_1}{f'_2}$.
Q6. Deduce the value of the focal length $f'_2$ of the eyepiece to choose in order to obtain an astronomical telescope with a magnification of 78.
2. Observation of Saturn’s rings
We use the astronomical telescope with magnification 78 modeled in the previous part to observe Saturn and try to distinguish its rings.
Data:
- average distance between the centers of the Earth and Saturn: D = 1,4×10⁹ km;
- distance between Saturn’s surface and the nearest end of ring C (closest ring considered visible): $d_{min}$ = 1,4×10⁴ km;
- distance between Saturn’s surface and the farthest end of ring A (farthest ring considered visible): $d_{max}$ = 7,7×10⁴ km;
- width of the Cassini Division: $d_{cassini}$ = 4,8×10³ km;
- radius of Saturn: R_S = 5,8×10⁴ km considered small compared with D.
Figure. Diagram of the distances: Saturn and the Earth are separated by D = 1,4×10⁹ km. Around Saturn, the disk of radius R_S is surrounded by rings C then A; $d_{min}$ is measured from Saturn’s surface toward the nearest visible inner edge of ring C; $d_{max}$ toward the outer edge of ring A; the Cassini Division is a dark annular band between two rings.
- minimum angle from which our eye can distinguish two very close objects: ε = 2,9×10⁻⁴ rad.
Figure. Diagram of angular resolution: two objects 1 and 2 seen by the observer’s eye under an angle θ; if θ < ε the observer cannot distinguish object 1 from object 2.
Q7. Describe, based on a calculation, what Saturn looks like to an observer during a naked-eye observation.
Q8. Determine the level of observation of Saturn (figure 1) that is reached with the astronomical telescope used.
The candidate is invited to take initiatives and present their approach even if it did not lead to a result. The approach followed is assessed and therefore needs to be clearly presented.
⏳ Solution not generated yet
Open this statement in Expert Maths AI: the step-by-step solution is computed on demand, checked by a second resolution, then published here for everyone.
📝 See the solutionHave a similar exercise? Get it solved step by step, for free.
🧮 Solve my exercise