Baccalauréat 2023 — Physics-Chemistry specialty, Polynésie française — exercise 1 : A chemist worth knowing: Karl Friedrich Mohr (official exam paper)
Statement
Karl Friedrich Mohr was a German chemist who lived in the nineteenth century. He introduced many techniques that advanced experimental chemistry. His discoveries remain useful every day in laboratories around the world.
The aim of this exercise is to illustrate, through three examples, Mohr’s main contributions to chemistry: Mohr’s salt, reflux heating, and titration.
Mohr’s salt.
Iron(II) ions $\mathrm{Fe^{2+}(aq)}$ are easily oxidized into iron(III) ions $\mathrm{Fe^{3+}(aq)}$ by the oxygen in air dissolved in aqueous solution. To minimize this oxidation and make it possible to store a solution of iron(II) ions, Mohr proposed using a hydrated ionic solid with the chemical formula: $\mathrm{(NH_4)_2Fe(SO_4)_2,\ 6H_2O(s)}$. In his honor, this solid is called “Mohr’s salt”.
Data:
- Atomic molar masses: $M(\mathrm{H})=1{,}0\ \mathrm{g\cdot mol^{-1}}$, $M(\mathrm{N})=14{,}0\ \mathrm{g\cdot mol^{-1}}$, $M(\mathrm{O})=16{,}0\ \mathrm{g\cdot mol^{-1}}$, $M(\mathrm{S})=32{,}1\ \mathrm{g\cdot mol^{-1}}$, $M(\mathrm{Fe})=55{,}8\ \mathrm{g\cdot mol^{-1}}$;
- Mohr’s salt contains ammonium ions $\mathrm{NH_4^+}$, iron(II) ions $\mathrm{Fe^{2+}}$ and sulfate ions $\mathrm{SO_4^{2-}}$.
Q1. Write the electron half-equations of the redox couples $\mathrm{Fe^{3+}(aq)/Fe^{2+}(aq)}$ and $\mathrm{O_2(aq)/H_2O(l)}$. Use these half-equations to justify the reaction equation modeling the oxidation of iron(II) ions by oxygen in acidic medium:
$4\mathrm{Fe^{2+}(aq)}+\mathrm{O_2(aq)}+4\mathrm{H^+(aq)}\rightarrow 4\mathrm{Fe^{3+}(aq)}+2\mathrm{H_2O(l)}$.
A volume $V$ equal to 100,0 mL of an aqueous solution of Mohr’s salt is prepared by dissolving a mass $m$ of solid equal to 2,00 g. The following equation models the dissolution of Mohr’s salt in water:
$\mathrm{(NH_4)_2Fe(SO_4)_2,\ 6H_2O(s)}\rightarrow 2\mathrm{NH_4^+(aq)}+\mathrm{Fe^{2+}(aq)}+2\mathrm{SO_4^{2-}(aq)}+6\mathrm{H_2O(l)}$.
Q2. Verify that the molar mass $M_{sel}$ of Mohr’s salt is equal to $392{,}0\ \mathrm{g\cdot mol^{-1}}$.
Q3. Calculate the concentration $c$ of introduced solute. Then show the advantage of Mohr’s salt by explaining how the amount-of-substance concentration $[\mathrm{Fe^{2+}}]$ of the iron(II) ions present in the resulting solution can be easily determined.
Reflux heating.
Mohr developed the device known as “reflux heating”, shown in figure 1, which revolutionized synthetic chemistry.
Figure 1. Reflux setup: a heated round-bottom flask is vertically topped by a vertical condenser. The flask is placed on a heating mantle or heating device, itself placed on a scissor lift. The numbered elements are: 1, vertical condenser; 2, flask; 3, heating device; 4, lift.
Q4. Name on the answer sheet the elements of the setup in figure 1 numbered 1 to 4.
We are interested in the synthesis of an ester with a rum odor: ethyl methanoate. The reaction mixture consists of a volume $V_{Ac}$ equal to 7,0 mL of methanoic acid, a volume $V_{Al}$ equal to 10,0 mL of ethanol, and a few drops of concentrated sulfuric acid. The esterification transformation taking place in the flask can be modeled by the following reaction equation:
$\mathrm{HCO_2H(l)}+\mathrm{C_2H_6O(l)}\rightleftharpoons \mathrm{HCO_2C_2H_5(l)}+\mathrm{H_2O(l)}$.
Data table:
- Methanoic acid: semi-developed formula $\mathrm{HC(=O)-OH}$; molar mass $M_{Ac}=46{,}0\ \mathrm{g\cdot mol^{-1}}$; boiling point 100,7 °C; safety pictogram: corrosive.
- Ethanol: semi-developed formula $\mathrm{CH_3-CH_2-OH}$; molar mass $M_{Al}=46{,}0\ \mathrm{g\cdot mol^{-1}}$; boiling point 78,5 °C; safety pictogram: flammable.
- Ethyl methanoate: semi-developed formula $\mathrm{HC(=O)-O-CH_2-CH_3}$; molar mass $M_{Es}=74{,}0\ \mathrm{g\cdot mol^{-1}}$; boiling point 54,3 °C; safety pictograms: irritant/harmful and flammable.
Q5. Name the functional groups present in these three molecules.
Q6. Draw the skeletal formula of ethyl methanoate.
Q7. State two advantages of reflux heating and indicate one precaution to observe when carrying out this synthesis.
Q8. Indicate the role played by sulfuric acid, which does not appear in the reaction equation for the synthesis.
Data:
- Density of methanoic acid: $\rho_{Ac}=1{,}22\ \mathrm{g\cdot mL^{-1}}$;
- Density of ethanol: $\rho_{Al}=0{,}79\ \mathrm{g\cdot mL^{-1}}$.
Q9. Using the data, calculate the amounts of substance of methanoic acid $n_{Ac}$ and alcohol $n_{Al}$ of the reactants in the initial state. Justify that ethanol is the limiting reactant.
Q10. Under the experimental conditions, the yield $R$ of the synthesis is equal to 0,70. Calculate the mass $m$ of ester produced under these conditions.
To optimize the yield of this synthesis, it is possible to use a fractional distillation setup shown in figure 2.
Figure 2. Fractional distillation setup: a heated flask placed on a lift supports vertically a fractionating column, connected at the top to an inclined condenser sloping downward to the right. The distillate is collected in an Erlenmeyer flask placed on the right on a lift.
Q11. Using the boiling points provided in the data table, explain how the fractional distillation setup makes it possible to optimize the yield of the synthesis of ethyl methanoate.
Titration.
Karl Friedrich Mohr invented the titration technique, which uses a chemical transformation to determine the amount of substance of a chemical species in solution. He designed the essential tool for this technique: the graduated burette closed at its lower end by a stopcock or by a “Mohr clip” (figure 3).
Figure 3. Mohr burette in a historical titration setup: a vertical graduated burette is fixed on a stand; it ends with a stopcock above a beaker placed on the base of the stand.
Two solutions are available to carry out a titration:
- Solution S1 of potassium chloride $(\mathrm{K^+(aq)};\ \mathrm{Cl^-(aq)})$ with amount-of-substance concentration in chloride ions $c_1$ and volume $V_1=200{,}0\ \mathrm{mL}$.
- Solution S2 of silver nitrate $(\mathrm{Ag^+(aq)};\ \mathrm{NO_3^-(aq)})$ with amount-of-substance concentration $c_2=0{,}080\ \mathrm{mol\cdot L^{-1}}$.
We want to determine the amount-of-substance concentration $c_1$ in chloride ions.
Q12. Among solutions S1 and S2, identify the titrated solution and the titrant solution. Then indicate which solution must be placed in the burette.
The silver nitrate solution S2 is added slowly. The reaction supporting the titration produces a white precipitate of silver chloride:
$\mathrm{Ag^+(aq)}+\mathrm{Cl^-(aq)}\rightarrow \mathrm{AgCl(s)}$.
In the case of a titration of chloride ions, Mohr showed that the equivalence point could be detected in the presence of potassium chromate by the appearance of a brick-red precipitate. This particular titration technique is called the “Mohr method”.
The red precipitate appears for a volume $V_{2E}$ of solution S2 added equal to 7,5 mL.
Q13. Define the equivalence point of a titration, then, by explaining your reasoning, calculate the amount-of-substance concentration of chloride ions $c_1$.
It is also possible to determine the amount-of-substance concentration of chloride ions $c_1$ by conductimetric titration. If the conductivity of the reaction mixture is measured during the chemical transformation, the curve in figure 4 is obtained.
Figure 4. Conductimetric titration curve: graph of the conductivity of the mixture in siemens per meter (S·m⁻¹) as a function of the volume of titrant solution added in milliliters (mL). The horizontal axis runs from 0 to 25 mL with major graduations at 0, 5, 10, 15, 20 and 25 mL. The vertical axis runs from 0,00 to 0,10 S·m⁻¹ with graduations of 0,01 S·m⁻¹. The experimental points show a conductivity close to 0,040 S·m⁻¹ at 0 mL, which decreases slightly to about 0,036-0,037 S·m⁻¹ around 7 to 8 mL, then increases almost linearly: about 0,045 S·m⁻¹ at 10 mL, 0,055 S·m⁻¹ at 12 mL, 0,067 S·m⁻¹ at 15 mL, 0,078 S·m⁻¹ at 17 mL, 0,085 S·m⁻¹ at 19 mL and 0,090 S·m⁻¹ at 20 mL. The slope break is located around 7,5 mL.
Q14. Explain how this curve makes it possible to obtain the volume $V_{2E}$ of titrant solution added at the equivalence point of the titration.
Data:
- Conductivity $\sigma$ of an ionic solution (Kohlrausch’s law): $\sigma=\sum_i \lambda_i\times[\mathrm{ion}]_i$;
- Ionic molar conductivities $\lambda_i$ in $\mathrm{mS\cdot m^2\cdot mol^{-1}}$ at 25 °C: $\lambda(\mathrm{K^+})=7{,}3$, $\lambda(\mathrm{Cl^-})=7{,}6$, $\lambda(\mathrm{Ag^+})=6{,}2$, $\lambda(\mathrm{NO_3^-})=7{,}1$.
Q15. Using the data, justify without calculation the shape of the curve in figure 4.
⏳ Solution not generated yet
Open this statement in Expert Maths AI: the step-by-step solution is computed on demand, checked by a second resolution, then published here for everyone.
📝 See the solutionHave a similar exercise? Get it solved step by step, for free.
🧮 Solve my exercise