Baccalauréat 2024 — Physics-Chemistry specialty, Polynésie française (jour 2) — exercise 3 : Study of Leidenfrost effect (official exam paper)
Statement
EXERCISE 3 - STUDY OF LEIDENFROST EFFECT (5 POINTS)
Leidenfrost effect is the particular behavior of a drop of water placed on a very hot plate: it does not vaporize immediately or completely but remains for a few minutes in the liquid state above the plate, floating on a cushion of vapor. This phenomenon was first studied in 1756 by Johann LEIDENFROST.
Figure 1. Observation of the space between the heated base B and a drop d. Old illustration showing a drop above a heated plate. Caption: From “Heat: a mode of motion”, J. Tyndall, (1875), p. 158.
The aim of this exercise is to determine the value of the distance between the drop and the plate.
The lifetime is defined as the time after which the drop has completely evaporated after being deposited. This lifetime is studied experimentally as a function of the temperature of the plate on which a drop of volume 50 µL at 20 °C is placed. The results are shown in the graph below: for different temperatures, the lifetime and its uncertainty bar are given.
Figure 2. Lifetime of a 50 µL drop as a function of the plate temperature. Graph from “cold Leidenfrost effect”, Physics Olympiad 2015. Horizontal axis: temperature in °C, from 50 to 350 °C. Vertical axis: lifetime in seconds, from 0 to 200 s. Three zones are indicated by horizontal arrows at the top: zone A up to about 100 °C; zone B from about 100 °C to 180 °C; zone C beyond about 180 °C. Two dotted vertical lines mark about 100 °C and 180 °C. Experimental points with uncertainty bars: in zone A, important and variable lifetimes, for example about 170 s at 68 °C, 107 s at 80 °C, 65 s at 88 °C, then very small near 100 °C; in zone B, between 100 °C and 180 °C, lifetimes are close to 0 to a few seconds; in zone C, beyond 180 °C, the lifetime increases abruptly then remains high, about 140 to 150 s at 185–200 °C, then decreases gradually to about 85–120 s between 220 °C and 320 °C.
In the context of this exercise, zone A shown in Figure 2 is not of interest because the temperature associated with the lifetime values is lower than the boiling temperature of water. On the other hand, beyond this temperature (100 °C), two zones can be distinguished for which the behavior of the drop is different.
Q1. Using Figure 2, propose an argument to justify why zone B is not of interest for the study of Leidenfrost effect.
John Tyndall showed in 1875 that in zone C, beyond 180°C, called the Leidenfrost threshold, the drop can persist for a few minutes before vaporizing. To measure the thickness of the vapor cushion on which the drop floats, a light beam is sent between the drop and the plate.
When a laser beam of wavelength $\lambda$ is sent, the phenomenon shown in Figure 4 is observed on a screen placed at a distance $D = 2{,}00\ \mathrm{m}$. Let $a$ be the thickness of the vapor cushion between the drop and the heated plate.
Figure 3. Diagram of the situation. A horizontal laser beam arrives from the left and passes through the space $a$ between a horizontal heated plate and a Leidenfrost drop located above the plate. After passing through this space, the beam is diffracted: the two extreme rays form an angle $\theta$ above and below the initial axis. A vertical screen is placed at distance $D$ from the drop; on the screen appears a bright pattern of height $L$ between the first two minima, centered on the horizontal axis. The diagram shows $D$ between the drop and the screen, $L$ on the screen and $\theta$ between the horizontal axis and an extreme ray.
Figure 4. Photograph of the screen. A vertical diffraction pattern is observed: a large central spot stretched vertically, surrounded by smaller secondary spots above and below, aligned vertically.
Q2. Name the phenomenon observed in Figure 4.
Q3. Give a condition on the size of the space $a$, between the drop and the plate, for this phenomenon to be easily observable with a laser of wavelength $\lambda$.
Given:
➢ For a small angle expressed in radians, $\theta = \tan \theta$.
Q4. Using Figure 3, show that in the small-angle approximation, one can write $\theta = \dfrac{L}{2\cdot D}$.
Given:
➢ The angle $\theta$ depends on the wavelength $\lambda$ of the laser and on the space $a$ between the drop and the plate: $\theta = \dfrac{\lambda}{a}$.
Q5. Derive the expression for $a$ as a function of $D$, $L$ and $\theta$.
A reading of the photograph in Figure 4 using image-processing software gives the result shown in Figure 5.
Figure 5. Result of the analysis of the obtained photograph. Graph: luminous intensity in arbitrary unit as a function of position in m. Horizontal axis: position from 0,00 m to 0,25 m, with graduations every 0,05 m. Vertical axis: luminous intensity from 0 to about 250. The curve shows a very intense central spot, with a maximum close to 250 units around $x \approx 0{,}135\ \mathrm{m}$; the first minima framing the central spot are approximately around $x \approx 0{,}115\ \mathrm{m}$ and $x \approx 0{,}155\ \mathrm{m}$, which gives a central spot width of about 0,04 m. Weaker secondary maxima are visible on both sides: around 0,10 m, 0,08 m, 0,06 m and around 0,17 m, 0,19 m. Below the graph, a diagram reminds that the luminous intensity is measured on the bright spots along a horizontal measurement axis.
Q6. Using Figure 5, determine the value of the width of the central spot $L$.
Given:
➢ The wavelength $\lambda$ of the laser used is equal to 532 nm.
Q7. Calculate the value of the interval $a$ between the drop and the plate.
⏳ Solution not generated yet
Open this statement in Expert Maths AI: the step-by-step solution is computed on demand, checked by a second resolution, then published here for everyone.
📝 See the solutionHave a similar exercise? Get it solved step by step, for free.
🧮 Solve my exercise