Baccalauréat 2025 — Physics-Chemistry specialty, Asie remplacement — exercise 3 : Phosphorus determination in swimming pool water (official exam paper)
Statement
Water pollution can be due to different chemical species. Phosphorus pollution is often underestimated but can be the cause of green algae growth, and it can reduce the effectiveness of treatment products, which poses a problem, particularly in swimming pool basins.
Phosphorus exists in various forms: $\mathrm{PO_4^{3-}}$, $\mathrm{HPO_4^{2-}}$, $\mathrm{H_2PO_4^-}$ and $\mathrm{H_3PO_4}$. For the sake of simplicity, we will call these species « phosphorus species ».
The aim of this exercise is to carry out a quality control of swimming pool water in order to determine whether there is a risk of algae growth.
Data:
➢ acid-base couples of the phosphorus species with their $pKa$ values:
$\mathrm{H_3PO_4(aq)}/\mathrm{H_2PO_4^-(aq)}$ $pKa_1 = 2{,}1$ ;
$\mathrm{H_2PO_4^-(aq)}/\mathrm{HPO_4^{2-}(aq)}$ $pKa_2$ ;
$\mathrm{HPO_4^{2-}(aq)}/\mathrm{PO_4^{3-}(aq)}$ $pKa_3$.
The distribution diagram of the acid-base couples of the phosphorus species is shown in Figure 1.
Figure 1. Distribution diagram of the acid-base species of phosphoric acid. Description: the horizontal axis is pH from 0 to 14; the vertical axis gives proportions from 0 to 1. The $\mathrm{H_3PO_4}$ curve is close to 1 at very acidic pH then decreases and intersects that of $\mathrm{H_2PO_4^-}$ around pH $2{,}1$ at the proportion 0,5. The $\mathrm{H_2PO_4^-}$ curve is predominant between about pH 2,1 and 7,2, with a maximum close to 1 around pH 4,5. It intersects that of $\mathrm{HPO_4^{2-}}$ around pH $7{,}2$ at the proportion 0,5. The $\mathrm{HPO_4^{2-}}$ curve is predominant between about pH 7,2 and 12,3, with a maximum close to 1 around pH 10. It intersects that of $\mathrm{PO_4^{3-}}$ around pH $12{,}3$ at the proportion 0,5. The $\mathrm{PO_4^{3-}}$ curve becomes predominant at very basic pH, close to 1 around pH 14.
Q1. Using Figure 1, determine the value of $pKa_2$ of the couple ($\mathrm{H_2PO_4^-(aq)}$ / $\mathrm{HPO_4^{2-}(aq)}$) and the value of $pKa_3$ of the couple ($\mathrm{HPO_4^{2-}(aq)}$ / $\mathrm{PO_4^{3-}(aq)}$).
Q2. Draw the predominance diagram of these phosphorus species. Deduce the nature of the predominant phosphorus species in swimming pool water with $pH$ equal to $7{,}0$.
The phosphorus species are colorless. In order to perform a spectrophotometric determination, it is therefore necessary to add a specific reagent to the solution that will make it possible to form a colored compound.
The absorbance spectrum of the colored compound and the color wheel are given in Figure 2.
Figure 2. Absorbance spectrum of the colored compound and color wheel. Description: the spectrum shows absorbance $A$ as a function of wavelength $\lambda$ in nm from 400 to 800 nm. The blue curve increases from about $A=0{,}05$ at $400\ \mathrm{nm}$, $0{,}08$ at $450\ \mathrm{nm}$, $0{,}16$ at $520\ \mathrm{nm}$, $0{,}28$ at $600\ \mathrm{nm}$, $0{,}36$ at $660\ \mathrm{nm}$, reaches a maximum of about $0{,}39$ near $700\ \mathrm{nm}$, then decreases to about $0{,}31$ at $800\ \mathrm{nm}$. The associated color wheel indicates in particular: magenta 400 nm, blue 450 nm, cyan 500 nm, green 530 nm, yellow 570 nm, red 700 nm, with the complementary colors opposite each other on the wheel.
Q3. Using Figure 2 and explaining your reasoning, propose a wavelength value $\lambda$ at which it would be appropriate to set the spectrophotometer. Specify, with justification, the color of the colored compound formed after addition of the reagent.
In order to prepare a calibration set, we first seek to make a solution $S_0$ with amount-of-substance concentration in phosphorus species $C(S_0)=3{,}67\times10^{-3}\ \mathrm{mol\cdot L^{-1}}$.
The solid used for dissolution is potassium dihydrogen phosphate with empirical formula $\mathrm{KH_2PO_4}$. We then consider that all of the solid dissolves and that the amount of dissolved phosphorus species is equal to the amount of solid introduced.
Data:
➢ molar mass of solid potassium dihydrogen phosphate: $M(\mathrm{KH_2PO_4}) = 136\ \mathrm{g\cdot mol^{-1}}$.
Q4. Show that the mass $m$ to be weighed out to prepare solution $S_0$ in a volumetric flask of volume $V = 200\ \mathrm{mL}$ is approximately $100\ \mathrm{mg}$.
The mass concentrations in phosphorus species present in swimming pool water are relatively low (of the order of $0{,}05$ to $1{,}00\ \mathrm{mg}$ per liter of solution). That is why it is necessary to dilute this solution $S_0$ one hundred times beforehand to obtain a solution called S.
Q5. Write, in detail, the protocol for preparing solution S from solution $S_0$. Specify the glassware used as well as its volume.
A calibration set is finally prepared from solution S following the protocol below:
➢ a volume of solution S is taken according to the conditions summarized in the table below and placed in a $25{,}0\ \mathrm{mL}$ volumetric flask;
➢ a volume of $5{,}00\ \mathrm{mL}$ of specific reagent allowing formation of the colored complex is added to each flask;
➢ each solution is made up to the calibration mark with distilled water, the volumetric flask is then stoppered and shaken;
➢ the absorbance of each solution in the calibration set is then measured.
Table giving the mass concentrations of the prepared daughter solutions. Columns: $S_{F0}$, $S_{F1}$, $S_{F2}$, $S_{F3}$, $S_{F4}$. Row « Solution of total volume 25 mL ». Row « Volume of solution S (in mL) »: 0 ; 2,50 ; 5,00 ; 7,50 ; 10,0. Row « Mass concentration $C$ in phosphorus species in $\mathrm{mg\cdot L^{-1}}$ »: 0 ; 0,50 ; 1,00 ; 1,50 ; 2,00. Row « Measured absorbance »: 0,000 ; 0,080 ; 0,162 ; 0,231 ; 0,311.
The calibration curve corresponding to these daughter solutions has been plotted:
Figure 3. Graph showing the absorbance of the standard solutions as a function of their mass concentration $C$ in phosphorus species. Description: the horizontal axis represents the mass concentration $C$ in $\mathrm{mg\cdot L^{-1}}$ from 0 to a little more than 2,0; the vertical axis represents absorbance $A$ from 0 to about 0,325. The experimental points are approximately $(0;0{,}000)$, $(0{,}50;0{,}080)$, $(1{,}00;0{,}162)$, $(1{,}50;0{,}231)$ and $(2{,}00;0{,}311)$. A calibration line passes near these points and through the origin; its slope is close to $0{,}156\ \mathrm{L\cdot mg^{-1}}$.
Q6. Justify that the absorbance can be modeled by the relation $A = k\cdot C$ and verify that the coefficient $k$ has the value $0{,}156\ \mathrm{L\cdot mg^{-1}}$ using a method of your choice.
Before analyzing the swimming pool water sample, it is necessary to filter it through a Büchner funnel. The filtrate is thus recovered.
After filtration through a Büchner funnel, $V_{filtrat}=5{,}00\ \mathrm{mL}$ of the swimming pool water filtrate is recovered and placed in a $25{,}0\ \mathrm{mL}$ volumetric flask, to which $V_{réactif}=5{,}00\ \mathrm{mL}$ of specific reagent is added in order to obtain the colored complex. It is made up to the mark with distilled water and shaken.
The absorbance of the filtered and colored solution is then measured at the same wavelength as before. The measured absorbance is $A_{eau}=0{,}075$.
Data:
Table giving water quality as a function of the mass concentration in phosphorus species. Columns: « Mass concentration in phosphorus species (in $\mathrm{mg\cdot L^{-1}}$) » and « Water quality ». Rows: $0{,}05-0{,}2$ : Good ; $0{,}2-0{,}5$ : Fair ; $0{,}5-1{,}0$ : Poor ; Greater than $1{,}0$ : Very poor.
Source: SAGE Mayenne – January 2013
Source: BD Carthage®©IGN MATE 2001 Water Agency - CG
Q7. Using the data and the experimental results, give the quality of the swimming pool water studied.
⏳ Solution not generated yet
Open this statement in Expert Maths AI: the step-by-step solution is computed on demand, checked by a second resolution, then published here for everyone.
📝 See the solutionHave a similar exercise? Get it solved step by step, for free.
🧮 Solve my exercise