Brevet (DNB) 2026 — Physics-Chemistry general stream, Session 2026 — exercise 1 : Profiling floats and ocean measurements (official exam paper)
Statement
Designed to carry out measurements to answer oceanographers’ questions, profiling floats are essential robots in the global ocean observation program. Equipped with sensors, profiling floats measure and transmit temperature, pressure, salinity, pH, the amount of dissolved dioxygen, ...
Iconographic document: photograph of a yellow cylindrical profiling float being handled from a ship above the sea. Source: www.adoptafloat.com (accessed on 23/01/2026).
Question 1 (1 point)
Name two quantities that the sensors on the floats can measure.
MEASUREMENT OF THE SALINITY OF SEAWATER
Salinity is the amount of dissolved salts in a liquid. In seawater, it mainly corresponds to the amount of chloride ions $Cl^-$ and sodium ions $Na^+$.
Question 2 (2 points)
Among the compositions listed in the table below, choose and write on your answer sheet the number of the correct composition of the chloride ion. Justify your choice.
Table of proposed compositions:
- Composition 1: 16 electrons; 17 protons; 18 neutrons.
- Composition 2: 17 electrons; 17 protons; 18 neutrons.
- Composition 3: 18 electrons; 17 protons; 18 neutrons.
CONDUCTIVE SOLUTIONS
To study the ability of seawater to conduct electric current, the electrical setup shown below is used:
Electrical setup diagram: a generator labeled G is placed at the top of the circuit, with the negative terminal on the left and the positive terminal on the right. A lamp is placed on the left branch of the circuit. Two electrodes are immersed in a tank containing the tested solution; the left electrode is connected to the lamp, and the right electrode to the positive terminal of the generator. A legend indicates: “Electrode*”, “Electrode”, “Tank”, “Tested solution”. *Electrode: conductive rod allowing electric current to pass through.
The observations from four experiments are listed in the table below:
Table:
- Experiment A: tested solution: pure water; composition of the solution: water molecules; observation: the lamp does not light up.
- Experiment B: tested solution: 50 g of salt dissolved in 1 liter of pure water; composition of the solution: water molecules, chloride ions and sodium ions; observation: the lamp lights up a little.
- Experiment C: tested solution: 100 g of salt dissolved in 1 liter of pure water; composition of the solution: water molecules, chloride ions and sodium ions; observation: the lamp lights up a lot.
- Experiment D: tested solution: 100 g of sugar dissolved in 1 liter of pure water; composition of the solution: water molecules and sugar molecules; observation: the lamp does not light up.
Question 3 (2 points)
Using the observations from the experiments, explain whether ions or molecules allow current to pass through the solutions.
The quality of the writing is taken into account and rewarded in this question. A minimum of 2 lines is expected.
To measure precisely the intensity of the electric current flowing in the circuit, it is possible to replace the lamp with a suitable measuring device.
Question 4 (1 point)
Give the name of the device used to measure electric current intensity in ampere.
The measurements made are presented in the form of a graph:
Graph titled “Variation of electric current intensity as a function of the mass of salt dissolved in one liter of water”. Vertical axis: “Current intensity (A)”, marked from 0 to 0,9 A in steps of 0,1 A. Horizontal axis: “Mass of salt dissolved in 1 liter of water (g)”, marked from 0 to 120 g in steps of 20 g. The experimental points are connected by an increasing straight line; values read approximately: 0 g → 0 A; 20 g → 0,15 A; 40 g → 0,30 A; 60 g → 0,50 A; 80 g → 0,72 A; 100 g → 0,84 A.
Question 5 (1 point)
Determine the mass of salt dissolved in one liter of water for an electric current intensity measured at 0,5 A.
DATA TRANSMISSION VIA SATELLITE
The float can transmit its measurement data via a satellite orbiting the Earth. The transmission takes place when the satellite is vertically above the float.
Diagram: the Earth is represented by a disk. Around the Earth, a dotted circular path shows the satellite’s trajectory. The float is represented on the Earth’s surface, and the satellite is placed on the same vertical line above the float. A dotted vertical line connects the center of the Earth, the float, and the satellite. The labels indicate “Satellite”, “Float”, “Satellite trajectory” and “Earth”.
The satellite travels about 45 000 km to complete one full orbit around the Earth at a constant speed of 7,5 km/s.
Question 6 (2 points)
Show by calculation that the float can carry out only one measurement data transmission every 6 000 s. Any approach, even partial, will be taken into account.
Question 7 (1 point)
Explain the advantage of using several satellites.
⏳ Solution not generated yet
Open this statement in Expert Maths AI: the step-by-step solution is computed on demand, checked by a second resolution, then published here for everyone.
📝 See the solutionHave a similar exercise? Get it solved step by step, for free.
🧮 Solve my exercise